KUKKO Universal 2-Jaw Puller 90 X 100 MM Barcode/UPC No. 4021176321344 Prt No. 20-1+S-T Wt. 1.1 Kg.

$ 468.54

For removing gears, bearings, sprockets, synchronize bodies, etc., in tight or difficult-to-access spaces.


  • Extra-thin trapezoidal pulling hook with quick adjusting capability.
  • Parallel pulling hooks in every position, even with full load.
  • Pulling hooks with infinitely variable adjustment on the cross-beam.


  • The narrow, trapezoidal pulling jaws are suitable for extremely narrow, difficult to access places.
  • A manual adjustment knurl allows rapid loosening and adjusting of the extractor jaws on the cross-beam without using a wrench.
  • Can be installed on various pulling hooks and variable reach thanks to jaw extensions.










US t

ft lb

St. / pcs.
20-1+S-T       90     3 1/2      100    3 7/8  70 – 140 2 3/4 – 5 1/2       17     2,5       35    1.215      2.5    25.5        1

How it Works

  • The part due to be removed (e.g. a gear, pinion or ball bearing) is gripped from the outside. Tightening of the pressure screw and the resulting pressure removes the part from the shaft.
  • The puller must be positioned centrally for center shafts. If the shaft is not sitting centrally, the parts can be removed asymmetrically with pullers with parallel pulling hooks.

Safety Information

  • The pulling hooks’ sliding parts must always sit stably and fully on the cross-beam.
  • If several parts have to be removed, always follow a step-by-step process. Do not remove several parts at the same time.
  • The pulling hooks’ support surfaces must always be straight and sit fully beneath the part to be removed.
  • Do not use any electrical or pneumatic servo screwdrivers or hammer drills.
  • Protective blanket required.

Product Enquiry